Adjusting a Garage Door Repair Lantana TX with two springs requires careful attention to detail and following proper safety precautions.

This guide will walk you through the steps to adjust your garage door correctly. It’s important to note that garage doors can be dangerous, so if you are unsure or uncomfortable with any step, it’s best to consult a professional.

Before starting any work on your garage door, make sure to disconnect the power to the automatic opener and secure the door in its fully open position using a locking mechanism or clamps. This will prevent any accidental movement while you are working on it.

  1. Identify the springs: Look for the two springs located on either side of the garage door. They are typically mounted parallel to the horizontal tracks, above the door. These springs are responsible for counterbalancing the weight of the door.
  2. Determine the type of springs: Garage doors usually have either torsion springs or extension springs. Torsion springs are mounted above the door, while extension springs are mounted on either side of the door.
  3. Identify the spring type: If your garage door has torsion springs, they will be located on a bar above the door. Extension springs, on the other hand, will have a pulley system and a cable running through them.
  4. Understand spring adjustment: Adjusting the springs will either increase or decrease the tension. Tightening the springs will increase the tension, making the door heavier to lift, while loosening them will reduce tension, making the door lighter. It’s crucial to make small adjustments and test the door’s balance after each adjustment.
  5. Gather necessary tools: You will need a winding bar or a socket wrench to adjust torsion springs. For extension springs, you might need pliers or a similar tool to adjust the tension.
  6. Adjusting torsion springs: Insert a winding bar into one of the holes on the winding cone of the spring. Apply pressure in the direction that tightens the spring, either by pushing or pulling, depending on the setup. Make quarter-turn adjustments at a time, alternating between each spring, until you achieve the desired tension. Test the door’s balance by lifting it manually and observing how it stays in position when released.
  7. Adjusting extension springs: Extension springs have an adjustable pulley system. You can increase the tension by moving the S-hook or the eyelet to a higher hole on the track hanger. To decrease the tension, move it to a lower hole. Make small adjustments and test the door’s balance by opening and closing it manually.
  8. Test the balance: A properly balanced garage door should stay in any position without falling or rising. If the door doesn’t remain in place when partially open, it might be unbalanced. In that case, continue adjusting the springs until you achieve the desired balance.
  9. Regular maintenance: Once you’ve adjusted the springs, it’s important to perform regular maintenance on your garage door. Lubricate all moving parts, including hinges, rollers, and tracks, to ensure smooth operation. Inspect the springs periodically for signs of wear or damage and replace them if necessary.
  10. Safety precautions: Always prioritize safety when working on garage doors. Wear protective gear, such as safety glasses and gloves, and be cautious of the tension in the springs. If you’re unsure or uncomfortable with any step, it’s best to seek professional help.

By following these steps and exercising caution, you can adjust your Garage Door Repair Lantana TX with two springs. However, if you’re unsure or encounter difficulties during the process, it’s always advisable to consult a professional garage door technician.

Lantana Garage & Overhead Doors

3501 FM 407 #15, Lantana, TX 76226

940-400-3038