Programming a legacy Garage Door Repair Keller TX opener model 696CD B requires a few steps to ensure proper setup and functionality.

In this guide, we will walk you through the process in detail. Before proceeding, make sure you have the necessary tools and equipment, including the remote control and ladder if needed.

  1. Gather the Required Materials:
    • Remote Control: Locate the remote control that came with the garage door opener model 696CD B. If you don’t have the original remote, you may need to purchase a compatible replacement.
    • Ladder: If your garage door opener is installed on the ceiling, you might need a ladder to access it.
    • Batteries: Ensure that the batteries in the remote control are fresh and functional.
  2. Prepare the Garage Door Opener:
    • Disconnect Power: To ensure safety during programming, disconnect the power to the garage door opener by unplugging it from the power outlet or turning off the circuit breaker.
  3. Set Up the Remote Control:
    • Locate the “Learn” Button: On the garage door opener unit, find the “Learn” button. It is typically located on the back or side of the motor unit. The button may be round or rectangular in shape and can vary in color (often red, yellow, or purple).
    • Press the “Learn” Button: Press and hold down the “Learn” button until the indicator light on the motor unit turns on. This light indicates that the garage door opener is ready to receive a new remote control code.
  4. Program the Remote Control:
    • Press the Desired Button: On the remote control, choose the button you wish to use to operate the garage door. Press and release this button. The motor unit’s indicator light should blink or flash to confirm that it has received the signal from the remote control.
    • Test the Remote Control: Stand within range of the garage door opener (usually within 20-30 feet) and press the button you just programmed. The garage door should respond by opening or closing. If it doesn’t, repeat the programming process or consult the user manual for troubleshooting instructions.
  5. Program Additional Remote Controls (if needed):
    • Follow the same steps outlined in the previous section to program additional remote controls. Each remote control will require its own unique button on the unit and should be tested individually to ensure proper programming.
  6. Restore Power:
    • Once you have finished programming the remote control(s), reconnect the power to the garage door opener by plugging it back in or turning the circuit breaker back on.

Congratulations! You have successfully programmed your legacy garage door opener model 696CD B with a new remote control. You can now use the remote to conveniently open and close your Garage Door Repair Keller TX. If you encounter any issues during the programming process, refer to the user manual or contact the manufacturer’s customer support for further assistance.

Keller Garage & Overhead Doors

3529 Heritage Trace Pkwy#12, Keller, TX 76244

817-769-3540