Reprogramming a Clicker Garage Door Repair Medina OH keypad is a relatively simple process that involves clearing the existing code and programming a new one.

By following these step-by-step instructions, you will be able to reprogram your Clicker garage door keypad effectively. Please note that the exact steps may vary slightly depending on the model of your Clicker keypad, so it’s essential to consult the user manual for specific instructions.

  1. Clearing the Existing Code:
    • Locate the “Learn” or “Smart” button on your garage door opener motor unit. It is usually found near the antenna wire or the light cover. Press and release this button. The indicator light on the motor unit will illuminate or blink, indicating that the opener is in programming mode.
    • Within 30 seconds, press and hold the “Learn” or “Smart” button again until the indicator light turns off. This action clears the existing code from the opener’s memory.
  2. Programming a New Code:
    • On your Clicker keypad, locate the “Program” or “Learn” button. It is typically located on the side or back of the keypad.
    • Press and release the “Program” or “Learn” button. The keypad indicator light should illuminate or blink, indicating that it is ready to accept a new code.
    • Enter a new four-digit code of your choice on the keypad. Make sure to choose a code that is easy for you to remember but difficult for others to guess.
    • Press and hold the “Enter” or “Send” button on the keypad until the indicator light blinks or turns off. This action sends the new code to the opener motor unit.
    • Test the new code by entering it on the keypad and pressing the “Enter” or “Send” button. The garage door should open or close accordingly.
  3. Additional Programming Options:
    • Some Clicker keypads offer additional programming options, such as the ability to program multiple garage doors or control other devices. Consult your keypad’s user manual for specific instructions on these advanced features.
    • To program multiple garage doors, follow the same steps as above for each door, ensuring that you clear the existing code and program a new one for each opener.
    • Some Clicker keypads may require you to set a dip switch code on the keypad to match the one on the opener motor unit. Refer to the user manual for detailed instructions on setting the dip switch code if applicable.
  4. Troubleshooting:
    • If the keypad does not program successfully, repeat the steps starting from clearing the existing code. Ensure that you complete each step within the specified time limits.
    • Check the batteries in your Clicker keypad and replace them if necessary. Weak batteries can prevent proper programming.
    • If you encounter persistent issues, consult the troubleshooting section of your Clicker keypad’s user manual or contact the manufacturer’s customer support for further assistance.

Reprogramming your Clicker Garage Door Repair Medina OH keypad is a straightforward process, and by following these instructions carefully, you should be able to set a new code successfully. Remember to consult your keypad’s user manual for any specific instructions or troubleshooting information related to your model.

Medina Garage & Overhead Doors

3745 Medina Rd Suite H, Medina, OH 44256, United States

1-330-785-7630