Replacing a spring may seem daunting, but with the right tools and knowledge, it can be a manageable task. A worn-out or broken spring can hinder the proper functioning of your Garage Door Repair Harrisonville MO, posing safety risks.

This guide will provide you with a step-by-step process to change a garage door spring safely and effectively. Remember, if you’re unsure or uncomfortable with any step, it’s always best to consult a professional.

Tools and Materials Needed:

  1. Safety goggles and gloves
  2. Stepladder
  3. Adjustable wrench
  4. Vise grips
  5. C-clamps
  6. Socket wrench set
  7. New garage door spring (compatible with your door)
  8. Two winding bars
  9. Tape measure
  10. Lubricant spray
  11. Rag or cloth

Step 1: Ensure Safety Precautions Safety should always be a top priority when working with garage door springs. Put on safety goggles and gloves to protect your eyes and hands from potential injuries.

Step 2: Release Tension from the Old Spring Using a stepladder, locate the torsion spring mounted above the garage door. Place a C-clamp on the track just below the bottom roller to prevent the door from moving. Use vise grips to secure the torsion spring and prevent it from unwinding. This step releases tension from the spring, making it safer to remove.

Step 3: Remove the Old Spring Using an adjustable wrench or socket wrench, loosen and remove the bolts securing the torsion spring to the center bracket. Carefully detach the old spring from the bracket, ensuring you have a firm grip on it at all times.

Step 4: Measure and Order the New Spring Take accurate measurements of the old spring, including its length, inside diameter, and wire size. With these measurements, order a new garage door spring that matches the specifications of the old one. Consult a professional or the manufacturer if you’re unsure about the right spring to purchase.

Step 5: Install the New Spring Once you have the new spring, follow the reverse order of the removal process. Position the new spring on the center bracket and secure it with the appropriate bolts, tightening them with an adjustable wrench or socket wrench.

Step 6: Wind the New Spring Using the two winding bars, insert them into the winding cone holes on each side of the new spring. Slowly and carefully wind the spring by turning the winding bars in the appropriate direction as indicated by the manufacturer or the old spring’s markings. Follow the recommended number of turns to achieve the correct tension.

Step 7: Test the Door With the new spring in place, remove the C-clamp from the track and slowly raise the garage door. Observe its movement to ensure smooth operation and proper balance. If the door doesn’t open or close smoothly, you may need to adjust the tension by winding or unwinding the spring slightly.

Step 8: Lubricate and Maintain Apply a lubricant spray to all moving parts of the garage door, including the spring, hinges, and rollers. Regular maintenance will help prolong the lifespan of your garage door and ensure optimal performance.

Conclusion: Changing a Garage Door Repair Harrisonville MO spring requires careful attention to safety and adherence to proper procedures. By following this step-by-step guide, you can replace your garage door spring efficiently and effectively. However, if you feel uncomfortable or lack the necessary experience, it’s always advisable to seek professional assistance. Remember, safety should be your top priority throughout the entire process.

Team Taylor Garage Doors

1004 W Mechanic St #12, Harrisonville, MO 64701, United States

1-816-239-2371