Programming a Craftsman 315 Garage Door Repair Arlington TX opener involves a series of steps to sync the remote control with the opener unit. While the specific instructions may vary depending on the model and version of the opener, I’ll provide you with a general guide that should help you with the programming process.

Please note that it’s always a good idea to consult the user manual for your particular model for detailed instructions.

Before you begin, make sure you have the following items ready:

  1. Craftsman 315 garage door opener remote control.
  2. A stable ladder to access the opener unit.
  3. New batteries for the remote control (if needed).

Now, let’s proceed with the programming process:

Step 1: Clearing Existing Codes

  1. Locate the “Learn” or “Smart” button on the opener unit. This button is typically found near the hanging antenna wire or on the back panel.
  2. Press and hold the “Learn” button until the indicator light (LED) on the opener unit turns on and stays lit. This usually takes around 6-10 seconds.
  3. Release the “Learn” button. The indicator light should remain on, indicating that the opener unit is in programming mode. Any previously programmed remotes or codes will be cleared.

Step 2: Programming the Remote Control

  1. Decide on a button to use on your remote control for programming (e.g., Button 1).
  2. Press and release the “Learn” button on the opener unit. The indicator light will begin flashing, indicating that the unit is ready to receive a new code.
  3. Within 30 seconds, press and hold the desired button (Button 1) on the remote control. Keep holding until the opener unit’s indicator light flashes or the opener unit emits a sound. This indicates a successful programming.
  4. Release the button on the remote control.
  5. Test the programmed button by pressing it. The garage door should operate as expected.

Step 3: Programming Additional Remote Controls

  1. Repeat Step 2 for each additional remote control you want to program, using a different button (e.g., Button 2, Button 3) on each remote.
  2. Ensure that each programmed remote control works by testing the buttons and observing the garage door’s response.

Step 4: Programming Wireless Keyless Entry (Optional) If your Craftsman 315 garage door opener has a wireless keyless entry pad, you can also program it by following these steps:

  1. Locate the “Learn” or “Smart” button on the opener unit.
  2. Press and release the “Learn” button. The indicator light should start flashing.
  3. Within 30 seconds, enter a four-digit PIN of your choice on the keyless entry pad. Press the “Enter” or “Send” button.
  4. The opener unit’s indicator light should stop flashing, indicating a successful programming.
  5. Test the keyless entry pad by entering the four-digit PIN and observing if the garage door operates accordingly.

Step 5: Finalizing the Programming

  1. After completing the programming process, press the “Learn” button on the opener unit to exit the programming mode. The indicator light should turn off.
  2. Test all the programmed remotes, as well as the wireless keyless entry pad, to ensure proper functioning.

Remember, these instructions are meant to provide a general guideline for programming a Craftsman 315 Garage Door Repair Arlington TX opener. It’s crucial to refer to the user manual specific to your model for accurate instructions.

Garage Door Experts of North Arlington

711 Trinity Cir, Arlington, TX 76006, United States

817-383-2114