Garage Door Repair Heiskell TN is a critical task to ensure the safe and reliable operation of your garage door opener system.

By following the instructions outlined in this guide and taking necessary precautions, you can successfully wire your garage door sensors and enhance the safety of your garage.

: Preparation

  1. Gather Tools and Materials: Before you begin, gather the necessary tools and materials for the wiring process, including wire strippers, electrical tape, wire nuts, a screwdriver, and the instruction manual for your garage door opener.
  2. Read the Manual: Refer to the instruction manual provided with your garage door opener to understand the specific wiring requirements and safety precautions for the sensors.

: Identifying Sensor Wires

  1. Locate the Sensor Wires: Identify the wires coming from each sensor. These wires are typically color-coded, with one sensor having a set of wires with one color and the other sensor having a set with a different color.
  2. Identify the Common and Normally Open Terminals: Each sensor will have two wires: one for the common (COM) terminal and one for the normally open (NO) terminal.

: Mounting the Sensors

  1. Choose Sensor Locations: Determine the best locations to mount the sensors on either side of the garage door opening, typically about 6 inches above the ground.
  2. Secure the Sensors: Use screws or adhesive to securely mount the sensors to the mounting brackets or the wall, ensuring that they are aligned and facing each other.

: Connecting the Sensors

  1. Strip the Ends of the Wires: Use wire strippers to strip the insulation from the ends of the sensor wires, exposing the bare copper conductors.
  2. Connect the Wires to the Opener: Connect one wire from each sensor to the “COM” terminal and the other wire to the “NO” terminal on the garage door opener.
  3. Secure the Connections: Use wire nuts or screw terminals, depending on the type of terminals provided, to secure the connections and prevent them from coming loose.

: Testing the Functionality

  1. Power On the Opener: Turn on the power to the garage door opener and ensure that it is receiving electricity from the power source.
  2. Test the Sensors: Close the garage door and place an obstruction, such as a box or piece of wood, in the path of the closing door. The door should stop and reverse direction if the sensors are functioning properly.

: Adjusting and Fine-Tuning

  1. Adjust Sensor Alignment: If the door does not respond to the obstruction or if it stops and reverses prematurely, adjust the alignment of the sensors until they are properly aligned and facing each other.
  2. Test Again: Repeat the testing process to ensure that the sensors are properly aligned and functioning correctly.

Conclusion:

Garage Door Repair Heiskell TN is a crucial step in installing a garage door opener system and ensuring the safety of your garage. By following the step-by-step instructions outlined in this guide and consulting the manufacturer’s instructions for specific details, you can successfully wire your garage door sensors and enjoy enhanced safety and peace of mind.

Camco Commercial Door Company

853 East Wolf Valley Rd. Heiskell, TN 37754

1-865-776-9455