I have had trouble with my garage door for quite some time. It seemed that no matter what I did, cold air and moisture always found their way into my garage. This not only made my garage uncomfortable to be in, but it also resulted in higher energy bills as my heater struggled to keep up. After doing some research, I realized that the problem was likely due to the fact that my garage door was not sealed properly.

We will discuss the steps involved in sealing a garage door based from Garage Door Repair Frisco TX, which will help you protect your garage from these issues.

I started by examining the garage door for any gaps or cracks that might be allowing air or moisture to seep in. Sure enough, I found several problem areas that needed to be addressed. I also noticed that the weather-stripping and bottom seal were worn and needed to be replaced.

To begin the sealing process, I first cleaned the garage door thoroughly. I used a detergent and water to wash the door, paying special attention to the areas that needed to be sealed. I then allowed the door to dry completely before proceeding to the next step.

Next, I installed new weatherstripping around the edges of the garage door. This helped to close the gaps and spaces that were allowing air and moisture to enter. I also replaced the bottom seal, which helped to prevent drafts and moisture from entering the garage from underneath the door.

After sealing the edges and bottom of the garage door, I realized that there were still gaps between the panels that needed to be addressed. I used a sealant to fill in these gaps, making sure that it was spread evenly.

Finally, I checked for any additional gaps or spaces that might be allowing air or moisture to enter the garage. I found a few gaps around the windows and doors leading into the garage, which I sealed using weatherstripping and sealant.

Once I had finished sealing the garage door, I closed it and inspected it from the outside for any gaps or spaces. To my relief, I didn’t see any. I also tested the seal by shining a flashlight around the edges of the door to see if any light was seeping through. Again, there were no signs of any gaps or spaces.

Overall, as stated in Garage Door Repair Frisco TX, sealing my garage door was a relatively easy and straightforward process. It has made a huge difference in the comfort level of my garage and has also helped to reduce my energy bills. I’m glad that I took the time to address this issue, and I would recommend it to anyone who is experiencing similar problems with their garage door.

BH Garage Door & Gate of Frisco

4350 Main St Suite 160, Frisco, TX 75034

972-366-4079