Resetting a Genie Garage Door Repair opener is a fairly simple process that can be done by following a few steps.

Below are the instructions to reset your Genie garage door opener:

  1. Identify the type of Genie garage door opener you have: Before starting the reset process, it’s important to determine the type of Genie garage door opener you own. Genie produces various models, and the reset process may vary slightly depending on the specific model.
  2. Locate the “Learn” or “Program” button: Look for a small button on the motor unit of your Genie garage door opener. This button is typically located on the back or side of the unit. It is often labeled as “Learn” or “Program.”
  3. Prepare the remote control: Make sure you have the remote control that operates the garage door opener. If you have multiple remotes, you can use any one of them for the reset process.
  4. Clear the remote control’s memory: Press and hold the “Learn” or “Program” button on the motor unit until the LED light beside it turns on and then off. This clears the memory of the opener, removing any previously programmed remotes.
  5. Program the remote control: Within 30 seconds of clearing the memory, press and release the “Learn” or “Program” button once again. The LED light should turn on.
  6. Press the button on the remote control: Hold the remote control close to the motor unit and press the button you wish to program on the remote. The LED light on the motor unit should flash or blink to indicate that it has received the signal from the remote.
  7. Test the remote control: Stand clear of the garage door and press the programmed button on the remote control. The door should respond by opening or closing. If it doesn’t, repeat the programming process, ensuring that you follow each step accurately.
  8. Repeat for additional remotes: If you have more than one remote control, repeat steps 6 and 7 for each remote to program them to the garage door opener.
  9. Confirm successful programming: Once you have programmed all the remotes, test each one to ensure they are functioning correctly. Open and close the garage door using each remote to verify that they are working as expected.
  10. Resetting the keypad (if applicable): If your Genie garage door opener has a keypad, you may need to reset it separately. Refer to the manufacturer’s instructions specific to your model to learn how to reset the keypad.

Remember that these instructions provide a general guideline for resetting a Genie Garage Door Repair opener. The exact process may vary depending on the model and specific features of your opener. Always consult the manufacturer’s manual or website for detailed instructions tailored to your specific model.

Atlas Door Company

6817 Sundance Cir W, Joshua, TX 76058, United States

1-817-295-3660