The Garage Door Repair Salado TX spring plays a critical role in the proper functioning of an overhead garage door. These springs counterbalance the weight of the door, making it easy to open and close manually or with a garage door opener. However, due to wear and tear, springs may break or lose their tension over time, necessitating replacement. While replacing garage door springs can be a challenging task, with the right tools and knowledge, it can be done safely and effectively.

In this guide, we will walk you through the process of replacing overhead garage door springs step-by-step.

  1. Safety Precautions

Safety is paramount when dealing with garage door springs, as they are under immense tension and can cause serious injuries if mishandled. Before beginning any work, ensure you have the following safety equipment:

  • Safety glasses
  • Heavy-duty work gloves
  • Stepladder or sturdy platform
  • C-clamps or vice grips
  1. Identify the Spring Type

There are two main types of overhead garage door springs: torsion springs and extension springs. Torsion springs are mounted above the door, while extension springs are located on either side. Identify the type of springs your garage door uses before proceeding with the replacement.

  1. Gather Necessary Tools

For replacing garage door springs, you will need the following tools:

  • Winding bars (for torsion springs)
  • Adjustable wrench
  • Socket set
  • Vice grips or locking pliers
  • Safety cables (optional but recommended for torsion springs)
  • New garage door springs (ensure they match the old ones in size and weight capacity)
  1. Release Tension (Torsion Springs)

To avoid injury, you must release the tension in the old torsion springs before removing them. This can be done using winding bars and following these steps:

a. Disconnect the garage door opener and unplug it from the power source.

b. Open the garage door fully to relieve some of the tension on the springs.

c. Place vice grips or C-clamps on the garage door track to prevent it from moving.

d. Insert the winding bars into the winding cone holes on the spring and slowly unwind the spring by turning the bars away from the center.

e. Once the tension is released, remove the old springs carefully.

  1. Remove Extension Springs

For extension springs, follow these steps:

a. Open the garage door fully and secure it in place with C-clamps or vice grips.

b. Detach the safety cables if your garage door has them.

c. Use an adjustable wrench or socket set to loosen the nuts securing the springs to the brackets.

d. Slowly release the tension by gently lowering the garage door until the springs are completely relaxed.

e. Slide the old extension springs off the brackets.

  1. Install New Springs

a. Install Torsion Springs: i. Slide the new springs onto the torsion tube. ii. Wind the springs using the winding bars in the opposite direction to that used for removal. iii. Reconnect the safety cables if applicable.

b. Install Extension Springs: i. Place the new springs onto the brackets. ii. Slowly lift the garage door to apply tension to the springs. iii. Secure the springs to the brackets with nuts.

  1. Test the Garage Door

With the new springs in place, test the garage door’s operation manually and with the garage door opener (if applicable). Ensure it opens and closes smoothly and without any unusual noises.

Conclusion:

Replacing overhead Garage Door Repair Salado TX springs requires careful attention to safety and proper technique. Always remember to follow safety precautions, identify the spring type, and use the right tools. If you’re uncertain about the process, it’s best to seek professional assistance to ensure a safe and successful replacement. With this step-by-step guide, you can confidently tackle the task of replacing overhead garage door springs and maintain the smooth operation of your garage door for years to come.

Salado Garage Doors

229 N Main St, Salado, TX 76571, United States

1-254-345-4058