Garage door sensors are an essential safety feature designed to prevent the door from closing on people or objects in its path. If the sensors are not properly aligned, the door may not close, or it may close improperly, which can pose a significant safety hazard. Fortunately, realigning garage door sensors is a relatively simple process that can be done with just a few tools.

Before attempting to realign the sensors, it’s important to ensure that the door is functioning correctly. Check for any damage or obstructions that may be preventing the door from opening or closing properly. If there is a problem with the door itself, it should be repaired before attempting to realign the sensors.

Once you have confirmed that the door is functioning correctly, it’s time to realign the sensors.

Here’s how to do it based from Phoenix Garage Door:

  1. Locate the sensors: The sensors are typically located near the bottom of the garage door, on either side of the opening. They are usually attached to the wall or the door frame with screws.
  2. Check the alignment: Look at the sensors to see if they are aligned properly. The two sensors should be facing each other directly, with no obstructions in between. If the sensors are not aligned, they will need to be adjusted.
  3. Adjust the sensors: To adjust the sensors, first, loosen the screws that hold them in place. Once the screws are loose, you can move the sensors to the correct position. Use a level to ensure that both sensors are at the same height and facing each other directly.
  4. Tighten the screws: Once the sensors are aligned properly, tighten the screws to secure them in place. Be careful not to over-tighten the screws, as this can damage the sensors.
  5. Test the sensors: Test the sensors by opening and closing the garage door. If the sensors are properly aligned, the door should close without any issues. If the door still doesn’t close, you may need to repeat the process or call a professional for further assistance.

It’s important to note that garage door sensors are a safety feature and should be checked regularly to ensure that they are functioning correctly. Realignment may be necessary from time to time, especially if the sensors have been bumped or moved. Keeping the sensors in good working order can help prevent accidents and injuries.

In addition to realigning the sensors, there are a few other things you can do to ensure that your garage door is functioning correctly:

  1. Check the tracks: The tracks that guide the garage door should be clean and free from debris. If the tracks are dirty or obstructed, the door may not function properly.
  2. Lubricate moving parts: Use a silicone-based lubricant to lubricate the moving parts of the garage door, such as the springs, hinges, and rollers. This will help the door move smoothly and quietly.
  3. Check the springs: The springs that support the weight of the garage door can wear out over time. If the springs are damaged or worn, they will need to be replaced.
  4. Call a professional: If you are not comfortable working on your garage door, or if you are not sure what is causing the problem, it’s best to call a professional for assistance. A garage door technician can diagnose the problem and make the necessary repairs to ensure that your door is functioning safely and correctly.

In conclusion, as per Phoenix Garage Door, realigning garage door sensors is a simple process that can help prevent accidents and injuries. By following these steps and taking care of your garage door, you can ensure that it functions correctly and safely for years to come.

Acclaim Garage Door Repair of Phoenix

1107 E Bell Rd UNIT 16, Phoenix, AZ 85022, United States

602-833-1218