Programming a Craftsman garage door opener is a simple process that requires following a few steps.

Here’s a step-by-step guide from Garage Door Repair Oxnard CA on how to program your Craftsman garage door opener:

Materials you will need:

  • Craftsman garage door opener
  • Step ladder (if needed)

Step 1: Clear the Memory If you have previously programmed the Craftsman garage door opener to a different door or frequency, it is essential to clear the memory before starting the programming process. To do this, press and hold the “learn” button on the back of the Craftsman garage door opener until the LED light turns off.

Step 2: Determine the Frequency Next, you need to determine the frequency of your garage door opener. Look at the back of your garage door opener motor unit, and you should see a label indicating the frequency. It could be either 315MHz or 390MHz.

Step 3: Set the Code Switches Once you know the frequency of your garage door opener, set the code switches on the back of the Craftsman garage door opener to match the frequency. If your garage door opener uses 315MHz frequency, set the code switches to the “ON” position. If your garage door opener uses 390MHz frequency, set the code switches to the “OFF” position.

Step 4: Program the Craftsman Garage Door Opener To program the Craftsman garage door opener, stand close to the garage door opener motor unit with the remote control in hand. Press and release the “learn” button on the back of the garage door opener motor unit. You should see an LED light on the motor unit flash.

Next, press and hold the button on the remote control that you want to program. The LED light on the garage door opener motor unit will flash again, indicating that the programming is successful.

Step 5: Test the Craftsman Garage Door Opener To test the Craftsman garage door opener, stand clear of the garage door and press the button you just programmed on the remote control. The garage door should open or close, depending on the button you pressed.

Step 6: Program Additional Remotes If you have more than one remote control that you want to program, follow the same process outlined above for each additional remote control.

That’s it! With these steps from Garage Door Repair Oxnard CA, you can easily program your Craftsman garage door opener and start using it to operate your garage door. If you encounter any issues during the programming process, refer to the instruction manual that came with the Craftsman garage door opener or contact the manufacturer for assistance.

OXR Overhead Garage Doors

1301 Seabridge Ln #3, Oxnard, CA 93035, United States

805-800-8965