easuring for a new Garage Door Repair Ontario CA is a crucial step in ensuring a proper fit and functionality.

Garage doors come in various sizes and styles, so getting accurate measurements is essential for a successful installation. In this guide, we will walk you through the process step by step, providing detailed instructions to help you measure for a new garage door.

Tools and Materials Needed:

  1. Tape measure
  2. Step ladder
  3. Pencil and paper
  4. Helper (optional)

: Gather Information

Before you start measuring, gather some essential information:

  • Door Type: Determine whether you need a single or double garage door. Single doors typically measure 8 to 10 feet wide, while double doors can range from 16 to 20 feet or more.
  • Door Style: Decide on the style of the garage door you want, such as sectional, roll-up, swing-out, or side-hinged. The style may affect the measuring process.

: Measure the Width

  1. Open your existing garage door if you have one. Measure the width of the opening from one side to the other. Make sure to measure the widest point of the opening. This measurement is typically taken from the inside of the frame.
  2. If you don’t have an existing door or if you’re planning to change the size of the opening, determine the desired width. Keep in mind that standard single doors are around 8 to 10 feet wide, while double doors are 16 to 20 feet wide or more.
  3. Write down the width measurement. Be precise and double-check your measurement for accuracy.

: Measure the Height

  1. Using a step ladder, measure the height of the garage opening from the floor to the top of the opening. Again, measure at the highest point and from the inside of the frame.
  2. If you plan to install an opener, measure the distance from the floor to the ceiling. This measurement will help determine if you have enough clearance for the opener’s installation.
  3. Note down the height measurement.

: Measure the Headroom

Headroom refers to the space between the top of the door opening and the ceiling. It’s essential for the proper installation of the garage door and any necessary hardware.

  1. Measure the headroom by placing your tape measure at the highest point inside the opening and extending it vertically to the ceiling. This measurement should be at least 12 inches for standard residential garage doors.
  2. If you have limited headroom, consider low-headroom or even vertical-lift garage door systems, which require less clearance.

: Measure the Side Room

Side room is the space between the sides of the opening and the nearest walls or obstructions. This measurement ensures that the garage door tracks can be properly installed.

  1. Measure the side room on both sides of the garage door opening. Place your tape measure against the inside of the frame and measure horizontally to the nearest wall or obstruction.
  2. Make a note of the side room measurement for each side.

: Check for Obstructions

Inspect the entire garage opening for any obstructions that might affect the installation of the new door. Look for pipes, electrical wires, or any structural elements that could interfere with the tracks or the operation of the door.

: Consult with a Professional

If you’re uncertain about any aspect of measuring for a new garage door or if you have unique circumstances, it’s a good idea to consult with a professional garage door installer. They can provide guidance and ensure that your measurements are accurate and appropriate for your chosen door style.

Conclusion:

Measuring for a new Garage Door Repair Ontario CA requires attention to detail and accuracy. By following these steps and taking precise measurements of the width, height, headroom, and side room, you can ensure that your new garage door will fit perfectly and function correctly. Remember that when in doubt, seeking advice from a garage door professional is a wise choice to avoid any costly mistakes during installation.

Ontario Garage & Overhead Doors

1353 E 7th St, Ontario, CA 91764, United States

1-909-442-4206